Aurora - Removing the internal gear of an Eclipse V1 or Aurora
Removing the internal gear of an Eclipse version 1 or Aurora
1. The internal gear is pictured below; the Aurora gear is slightly smaller but is assembled the same way.
2. To remove the internal gear, first detach the black Winder Housing #31 by removing the four bolts. Be careful
not to loose the two small springs, metal clicker and the plastic spacer found under the springs. These items are
usually found under a small piece of tape to hold them in place.
3. Once the outer winder housing has been removed you will find the head of the Gear Spindle, to release it use
a ruler to protect the Mast #27 and pry off the black button on the reverse side with a flat head screwdriver.
4. You will find a small hex bolt behind the black button, this bolt has been applied with Loctite so take care not
to ruin the head. If you can't shift it, stop and use a hot air gun or hairdryer to heat the bolt to soften the Loctite
and break the bond. Using the handle on the opposite side can aid in removing this bolt.
Once you have removed the small bolt place a screwdriver in the hole and push out the Gear, the screwdriver
will keep the internal Winder Drum #32 from moving.
5. To replace the original Gear follow the instructions in reverse. It is recommended to reapply Loctite to all the bolts
upon assembly. These bolts are subjected to vibration and movement due to the winding action and can loosen over
time if Loctite or a similar medium strength locking product is not applied.
Related Articles
Eclipse V1 - Removing the internal gear
Removing the internal gear of an Eclipse version 1 or Aurora 1. The internal gear is pictured below; the Aurora gear is slightly smaller but is assembled the same way. 2. To remove the internal gear, first detach the black Winder Housing #31 by ...Eclipse V2 - How to Replace the Winder Unit (Video)
How to Replace the Winder Unit on the Eclipse V2 (Video) This video demonstrates the winder unit repair to the Riviera V2, this is the NZ version of the Eclipse V2, they are the same umbrella with the same parts and workings.Eclipse V1 - Replacing The Winder Drum
REPLACING THE WINDER DRUM If you find there is an excess of Cable hanging from the Mast #27 and or the Winder is not working then the internal anchor point on the Winder Drum #32 is more than likely broken. 1. To confirm that this is the problem you ...Aurora - Changing The Wire on Aurora/Eclipse V2
Changing the wire on an Aurora/Eclipse V2 For a copy of this manual, please print or download the Attachment. If you are working on an Eclipse, open the canopy of the umbrella with the roof removed by pushing up and locking the Slider Car Tilt Knob ...Eclipse V1- Changing The Wire on Eclipse V1
Changing the wire on an Eclipse V1 For a copy of this manual, please print or download the Attachment. 1. First lay your umbrella on its side on a pair of saw horses or a table. You will need to remove the Canopy, so start off by releasing the Top ...